Inventory -> Tube Mills -> HF/ERW ->
2-1/2" (63mm) X .095" (2.4mm) YODER #M2 ERW Tube Mill Line
Machine #2878
Machine Class: Tube Mills
Machine Type: HF/ERW
Click here to request more
information on this machine.
Specifications
UTUBE NUMBER: 2878
MANUFACTURER: YODER
MODEL NUMBER: M2
SERIAL NUMBER: Y 955
PRELIMINARY SPECIFICATIONS:
Hand of Operation: Right to Left
Maximum Tube Diameter: 2-1/2" (63 mm)
Minimum Tube Diameter: 1/2" (.508 mm)
Maximum Wall Thickness: .095" (2.4 mm)
Minimum Wall Thickness: .020" (0.50mm)
Maximum Line Speed: 150 FPM, Max. Gear In Speed, No Load
Maximum D/T Ratio: 60:1
Minimum D/T Ratio: 10:1
Maximum Material Yield: 50,000 PSI
GEAR BOX DATA:
Spindle Diameter: 2" (50 mm)
Roll Space Forming, Fin & Sizing: 13" (330 - 2 mm)
Horizontal Centers: 15" (279.4 mm)
YODER Gears
ENTRY EQUIPMENT:
1 - LITTELL #40-18 4,000 Lb. Single Uncoiler
4-Leaf, Manual Expansion, Electric Brake
FORMING MILL:
1 - Entry Guide Table, 4-Rolls w/Edge Trimming
3 - Driven Breakdown Stands
4 - Idle Side Rolls w/Vertical Adjustment
3 - Driven Fin Stands
WELDING SECTION:
1 - YODER ERW Welder, MG Set, 150 HP
1 - Seam Guide
1 - 2-Roll Weld Pressure Unit
1 - Scarfing Stand
1 - Seam Ironing Stand
1 - Bead Winder
1 - Coolant Section - Flood Type, 4 - 5'
SIZING MILL:
3 - Driven Sizing Stands
3 - Idle Side Rolls
1 - Straightener, Turkshead 4-Roll
CUT OFF:
1 - YODER P-40 Cut-Off, 4-Post, Single Cut
Motor: 7.5 HP, 1170 RPM
1 - Run Out Table, 20', Single Dump
MILL DRIVE:
1 - Single Motor CUTLER HAMMER Drive System
1 - 50 H.P., D.C Motor, 440/60/3
1 - Mill Control Panel
Condition: Good, Mill was Running until 3/2012
Click here to
request more information on this machine.
CARE IS TAKEN TO GIVE RELIABLE DESCRIPTIONS BUT THESE ARE NOT GUARANTEED.
PROSPECTIVE PURCHASERS ARE ADVISED TO CHECK VITAL DETAILS.
WE RESERVE THE RIGHT TO CORRECT STENOGRAPHIC ERRORS.
ALL MACHINERY IS SUBJECT TO PRIOR SALE.
Click Here For Conditions Of Sale
|
